• HQRP™ Solar Charge Controller plus HQRP™ Coaster;
• Self-consumption: 6mA maximum; Charging circuit voltage drop: 0.26V maximum;
• Discharging circuit voltage drop: 0.15V maximum; Type of Charging: series PWM;
• Strong backlight on < 23mA, 15 seconds; Low backlight on < 20mA, 15 seconds;
• Backlight and LED indicator off < 15mA; Communication cable: 1.5 meters. 200 days warranty!

Products trademarked HQRP™ are marketed and sold exclusively by Osprey-Talon. HQRP Solar Charge Controllers are high quality, efficient and reliable Solar Power Regulators. They are perfect for rural electrification system. They offer a lot of possibilities and benefits. LCD display: all systems parameters in digital value, system status as symbols; Intelligent software control; PWM charging mode; Battery type option; Battery Ah setting; Over-load, short circuit, polarity reverse protection, electronic fuse; Temperature compensation setting; Modify parameters through four keys. Solar Controller supports up to 300W of 12V Solar panels and up to 600W of 24V Solar panels. For 12V solar panels, please, use battery and load for 12V solar systems (For 24V solar panels, please, use battery and load for 24V solar systems).

Price: {price-updating}

Charge 4 AAs @ 100mA charge rate with this panel!These PowerFilmTM flexible solar modules can be used alone to direct-power your small DC project (anything that runs off 7.2V or less and requires 100mA of current or less) – or, they can be used in your battery-charger project to store energy for later use. BATTERY-CHARGING TIPS.For battery charging, the voltage of your solar panel MUST be higher than the voltage of the battery that you want to charge. We recommend using the following guidelines: at least 2.0 volts to charge one 1.2 volt battery ,at least 3.6 volts to charge two 1.2 volt batteries wired in series ,at least 4.8 volts to charge three 1.2 volt batteries wired in series ,at least 6.0 volts to charge four 1.2 volt batteries wired in series.Multiple panels can be wired together to increase voltage or current, and the panels can be cut (following directions!) for your special project.Each module is encapsulated in 3 mil clear polyester film.Specs: Output 100mA @ 7.2V ,Open-cir

Price: {price-updating}